Recommended for use with JP Low Mass Carriers or any other conventional mil-spec carrier where reduced mass is desired.

• Requires full-length extension tube.
• Not for use with AR-10-type rifles.
• Finish: Red Anodized
• Weight: 3oz

Made in the USA

[Scroll down for video]

Gen 2 Silent Captured Spring (patented) for AR-15-type rifles – Heavy

Running a suppressor and \want the quietest Ar-15 you can get? Look no further than JP’s Silent captured buffer spring.

Heavy version with Tungsten Weights

H2 Buffer Version

Includes spacer to allow for installation in both carbine- and rifle-length buffer tubes.

Recommended Use:

• Short-barreled rifles (SBRs)
• Suppressed weapons
• Rifles recommended to use an H2 buffer
• Select-fire rifles
• Piston-operated rifles

[Scroll down for video]

JP EZ Trigger Fire Control Package

This complete kit for .154 small pin receivers consists of a JP trigger with engagement and overtravel screws and disconnector spring installed as an assembly, disconnector, instructional video, and our standard array of springs: yellow reduced power trigger spring both yellow and red reduced power hammer springs.

Spring Selection Guide:

• Competition
  The yellow/yellow combination may be used for competition and various recreational applications with hand loads or domestic-manufactured, non-military ammunition. It will result in a release weight in the 3.0-3.5 lb. range on most receivers.
• Enhanced Reliability Competition/Recreation
  The yellow trigger spring combined with the red hammer spring will yield a release weight of 3.5-4.0 lbs. on most receivers and offers increased reliability for (5.56 NATO) or foreign-manufactured ammo with low sensitivity primers. The yellow-red springs must be used for any large-frame AR installation to ensure 100% ignition reliability. This is also the minimum acceptable combination for tactical duty (LE) installations and should be used only with domestic-manufactured ammo in this application.
• Duty/Defense
  The tactical spring set includes a full powers (grey) hammer spring (purchased separately) and yellow trigger spring. It may be required for agencies that mandate a trigger release weight of over 4 lbs. This set up also insures 100% ignition reliability on both AR-15 and AR-10 type rifles.
• CMP
  To meet NRA Service Rifle Competition rules of a 4.5 lb. release weight, the CMP spring set (purchased separately) includes the full-power hammer spring and a custom trigger return spring, which will allow you to tune to a release weight just over 4.5 pounds to lift the NRA weights.

JP Speed Hammer

.154 Small pin version

JP Oversize Anti-Walk Pins, .156 small pins (set of 2) and includes four (4) button head screws for a clean appearance, easy service and removal. Finish is black oxide.

Be aware that the JP Anti-Walk Pins are oversized and may require the pin holes in the trigger and hammer to be reamed with a carbide reamer. No modification to the lower receiver is necessary.

JP adjustable safety, reversible, including extra low profile ambi lever for AR-15 receiver. Can be used to eliminate the safety fitting process for the JPFC kits and provide perfect safety fit for many other aftermarket trigger systems.

Notice: Replacing any original JP fire control components with non-JP aftermarket components may render the JP adjustable safety nonfunctional by allowing the rifle to fire on safe. For example, some two-stage triggers will not interface with the JP adjustable safety, which will not fully block the trigger in the safe position and allow the trigger to function even with the safety engaged. If you install a non-JP trigger system in the JP adjustable safety, it is imperative to verify its function.

[Scroll down for video]